Image Access WideTEK 25-600 Setup Manual

Setup Manual Page 23
B.6 Connecting to the Power Source
Before connecting the scanner to the external power supply and the power supply to the
electrical outlet, check the following items:
Ensure the electrical outlet is in perfect condition and that it is
properly grounded.
Ensure that
the electrical outlet is equipped with a fuse with the
proper capacity.
The electrical outlet must be near this device and must be easily
accessible.
Inspect the power cable and ensure that it is undamaged.
Use only the power cable delivered with the scanner.
Turn the device off before plugging or unplugging any cable.
The connector for the external power supply and the main power switch are located at the
right side of the back of the housing, seen from the operator’s position (i.e. from the front
of the scanner).
After the power source is connected and the main power switch is turned on, the symbol
in the on/off button lights up.
Red illumination of the on/off button signals that the WideTEK 25-600 is in standby mode.

Image Access WideTEK 25-600 Specifications

General

Brand	Image Access
Model	WideTEK 25-600
Category	Scanner
Language	English