IMI Hydronic TA-SCOPE - Page 4

TA-SCOPE
4
Settings .....................................................................................................................................................37
Information ................................................................................................................................................39
PC Communication ...................................................................................................................................40
Transfer of Data 40
Software Upgrade 40
Instrument Care and Service ...................................................................................................................... 41
Batteries – Capacity & Charging 41
Filter Cleaning 42
Calibration Certificates 42
Guarantee..................................................................................................................................................43
FCC Notification and ETL Markings ...........................................................................................................44
Technical Specifications .............................................................................................................................45
Accessories ...............................................................................................................................................46
Note! The products, texts, photographs, graphics and diagrams in this brochure may be subject to alteration by
IMI Hydronic Engineering without prior notice or reasons being given. For the most up to date information about
our products and specifications, please visit www.imi-hydronic.com.
IMI Hydronic Engineering AB, 524 80 Ljung, Sweden.
!
TA-SCOPE includes software licensed from OMRON SOFTWARE Co., Ltd.
Advanced Wnn
©
OMRON SOFTWARE Co., Ltd. 2002 – 2010.
All rights reserved.
Contents
Warning! Beware of hot fluid in the valve. Always follow the sequence described in the manual
when connecting and disconnecting the measuring equipment.
!
Water temperature over 52°C (125°F) can cause severe burns instantly or death from scalds. Always consider
the risks of injury from hot water before starting any measurement on a heating system and follow relevant local
legislation, regulations, standards and good industry practice for working with pressurised hot water systems.
Always use appropriate personal safety equipment when working on a heating system. Examples of appropriate
safety equipment include (but are not limited to) a face shield, heat resistant rubber gloves and boots and a long
sleeved apron (long enough to cover the tops of the boots). Always wear your boots inside your trouser legs to
prevent/minimise any hot water flowing into your boots. IMI Hydronic Engineering will not take any responsibility
for injury howsoever caused by hot water during measurement.
Warning! The surface on the Dp Sensor can be hot while measuring on hot media.
Always use suitable safety equipment.
!
Warning! Both Handheld and Dp Sensor contain batteries which require charging. The supplied
multi-charger from IMI Hydronic Engineering must be used!
Warning! Do not open the instrument. This can damage the instrument and void your guarantee!
See page 43 for further information.
!
!
CAUTION! Read the user manual before using the product.
!