41
Instrument Care & Service
Instrument Care and Service
Care & Storage Recommendations
• TA-SCOPE can be cleansed with a damped cloth and a lenient cleaning-agent.
• Never leave water in the Dp Sensor when risk of freezing exists (i.e., in a car during winter)!
• Do not expose to extreme temperatures, the battery may explode if disposed of in fire.
• Storage above 60° C is not allowed.
• Other usage than specified in this manual may cause damage to the unit or user.
Batteries – Capacity & Charging
Upon delivery the TA-SCOPE is partly charged and prepared to start balancing immediately. The Information
bar on the Handheld displays the battery status for both Handheld and Dp Sensor whenever communication is
established.
The Handheld, Dp Sensor and TA-SCOPE Relays can be charged at the same time through the multi-charger.
The TA-SCOPE is delivered with one multi-charger and 2 DC-cables (i.e. the cable between unit and multi-charger).
A DC-cable is delivered with each extra TA-SCOPE unit (DpS or TA-SCOPE Relay).
The batteries installed in the TA-SCOPE are specifically designed for this application and may not be changed
under any circumstances. Contact your local IMI Hydronic Engineering sales office if you experience any battery
issues.
The time for charging from empty batteries is approximately six to seven hours and gives up to three full working
days of wireless performance.
The Handheld and DpS-Visio will also charge connected to the PC during transfer of measuring data and
software updates, see page 40.
OK Not OK
Tips! Maximise battery capacity by adjusting the settings for backlight, time to sleep mode and
time to switch-off. Power Saving options are reached from the Settings menu.
!
Warning! Do not open the instrument. This can damage the instrument and void your guarantee!
See page 43 for further information.
!
Warning! Both Handheld and Dp Sensor contain batteries which require charging. The supplied
multi-charger from IMI Hydronic Engineering must be used!
!
To Next Page
Loading...