Inficon XL3000flexRC - 6 Operation; Switching the Device on; Basic Settings; Setting the Language

6 | Operation INFICON
34 / 108 XL3000flex-Operating-instructions-jina83en1-07-(2105)
6 Operation
6.1 Switching the device on
►
Turn on the XL3000flex via the power switch on the back of the device, see “Device
setup [}14]“.
ð The system is starting automatically.
ð After the start-up, the green LED on the front cover of the XL3000flex lights up.
6.2 Basic settings
The device is assembled and preconfigured so that basic settings have already been
made.
To check or change settings, first take a look at the factory defaults. See factory
settings of the XL3000flex (Factory settings [}25]).
6.2.1 Setting the language
Select the display language. The factory setting is English. (The display on the
handle of the SL3000XL sniffer line shows messages in English instead of in
Russian and Chinese.)
German
English
French
Italian
Spanish
Portuguese
Russian
Chinese
Japanese
Control unit Main Menu > Settings > Setup > Control unit >
Language
LD protocol Command 398
ASCII protocol *CONFig:LANG