Inficon XL3000flexRC - Selecting the Type of Expansion Module; General Interface Settings (I;O Module)

INFICON Operation | 6
XL3000flex-Operating-instructions-jina83en1-07-(2105) 45 / 108
Favorite 2: Right button
Favorite 3: Button at the bottom right of the main menu
Volume
Display settings
Start/stop
Measurement display
ZERO
CAL
Flow switching
Check CAL
AQ Assistant (not applicable to XL3000flex!)
Gas equivalent
- - - (= nonfunctional)
Control unit Main menu > Settings > Favorites > Favorite 1 (2, 3)
6.2.19 Selecting the type of expansion module
Selecting the
expansion module
Selecting the type of module connected to the I/O connection
I/O module
Bus module
Control unit Main Menu > Settings > Setup > Interfaces > Device select. >
Module on I/O connection
or
Main Menu > Settings > Setup > Accessories > Device select. >
Module on I/O connection
LD protocol –
ASCII protocol –
6.2.20 General interface settings (I/O module)
Setting the interface
protocol
Setting the protocol for the module connected to the I/O connection. This setting can
be overwritten with the DIP switch on the IO1000.
LD
ASCII
Binary
LDS1000
Control unit Settings > Set up > Interfaces > Protocol > I/O module protocol
LD protocol 2593
ASCII protocol *CONFig:RS232