INFICON Warning and error messages | 7
XL3000flex-Operating-instructions-jina83en1-07-(2105) 79 / 108
7 Warning and error messages
The instrument is equipped with extensive self-diagnostic functions.
Error messages
Errors are events that the device cannot correct itself and that force interruption of its
operation. The error message consists of a number and a descriptive text.
After you have removed the cause of the error, start operation again with the restart
key.
Warnings
Warnings warn of device states that can impair the accuracy of measurements.
Operation of the device is not interrupted.
Confirm acknowledgment of the warning with the OK key or the right key on the sniffer
handle.
The following table displays all the warnings and error messages. It lists possible
causes for the malfunction and instructions on how to eliminate these.
Please note that work marked with an asterisk must be carried out only by service
staff that is authorized by INFICON.
Warning
(Wrn)
Error (Err)
Error message
LDS3000
Error number Limit values Cause
LDS1000
Protocol
Binary or
ASCII
protocol
compatibilit
y mode
LDS1000/
LDS2010
1xx system error (RAM, ROM, EEPROM, clock, ...)
Wrn102 Timeout EEPROM MSB
Box (Parameter number)
84 43 EEPROM on IF board or MSB
defective
Wrn104 An EEPROM parameter is
initializing
84 43 Following software update or
EEPROM defective
Wrn106 EEPROM parameter
initializing
84 43 Following software update or
EEPROM defective
Wrn110 Clock not set 16 16 Jumper for clock not set, battery
drained, clock defective
Wrn122 No response from the BUS
module
99 99 Connection to BUS module
interrupted
Wrn123 Unsupported configuration
INFICON from BM1000
99 99 The selected configuration is not
supported by the connected
INFICON BM1000-fieldbus type.
To Next Page
Loading...
