58
English
Problem Possible Solution
Power LED is ashing red,
is solid blue, and Temp LED
is ashing red
y The projector has overheated. The display automatically
shuts down. Turn the projector on again after cool down. If the
problem persists, contact InFocus.
y If the projector fan fails, the projector will automatically shut
down. Clear the projector mode by pressing and holding the
Power button for 10 seconds. Please wait for about 5 minutes
and try to power up again. If the problem persists, contact
InFocus.
The remote control is not
operating smoothly or
works only within a limited
range
y The battery may be low. If so, replace with a new CR2025
battery.
Status Indicators
Projector
Status
Description
Power
(Blue / Red)
Temp
(Red)
Illumination
(Red)
Standby
mode
Projector in Standby mode.
Ready to power on.
Red OFF OFF
Power on Projector in Normal mode, ready
to display an image.
Blue OFF OFF
Projector
overheated
Air vents might be blocked
or ambient temperature may
be above 35
º
C. The projector
automatically shuts down. Ensure
that the air vents are not blocked
and that the ambient temperature
is within operational range. If the
problem persists, contact us.
Red flashing Red OFF
Fan failure One of the fans has failed. The
projector automatically shuts
down. If the problem persists,
contact us.
Red flashing
and Blue ON
Red flashing
(0.5 seconds
off,
2 seconds on)
OFF
LED failure LED shutdown. Red flashing OFF Red
Note: If the projector fan fails, the projector will automatically shut down. Reset the projector mode
by pressing and holding the Power button for 10 seconds. Please wait for about 5 minutes
and try to power up again.
To Next Page
Loading...
