LP340/340B/350 Service Manual 60
Resetting the Lamp Timer
The lamp timer measures the number of hours a lamp is lit. Whenever you replace the lamp, you need to
reset the timer.
1 Plug the projector in and press the Power button above the I/O panel. The startup screen
appears.
2 Press and hold the Volume – button.
3 While holding the Volume – button down, press the Menu button for at least five seconds.
4 To confirm that the lamp timer has reset, press the Menu button, then select Show Status on the
Status menu.
5 The Lamp Hours Used line, located at the top of the Status box, should read 0000.
To Next Page
Loading...
