30 Keypads
Anti-intrusion control panels
CLEANING THE
DISPLAY
Touching the “Settings” option on the home page for at least 7 seconds disables the sensitivity
of the touch screen for 20 seconds. During this interval, the “CLEAN SCREEN” message is
shown to indicate that it is possible to clean the screen.
REBOOTING
Touching any part of the screen for 50 seconds will reboot the keypad.
6-1-3
Status icons on display
The icons that appear on the second line, on the right side of the LCD screen or on the top and
bottom bars of the Alien display, provide system information, therefore, their appearance or
status (fixed or flashing) depends on the status they must report:
Note
If duly programmed by the installer, the icon will be shown when Teleservice is enabled.
Table 6-4: Information icons
Icon Signalling
Joy, Aria/HG,
nCode, Concept
Aria/W Alien
Telephone line
Telephone line busy
Solid Solid
Telephone line down
Blinking Blinking
Lost
At least one peripheral device is not responding
Solid Solid
All the peripherals in the system configuration are
responding properly, however, loss of a peripheral
has been detected and cleared (Peripheral Loss
memory).
Animated Solid Blinking
Answerphone
Answerphone function enabled
Solid Solid
Teleservice
Teleservice enabled (for future use)
Solid Solid
Key
False key
Blinking Solid Blinking
Tamper disabled
The tamper protection on the Alien keypad is dis-
abled
Solid
Peripheral tamper
At least one peripheral (keypad, reader, expan-
sion) is in tamper status (enclosure open or dis-
lodged)
Solid Solid
All peripherals are properly placed and all enclo-
sure covers are closed, however, tamper was pre-
viously detected and cleared (Tamper memory).
Animated Solid Blinking
Control panel Tam-
per
The Control panel is in tamper status (enclosure
open or device dislodged).
Solid Solid
The Control panel is properly placed and the enclo-
sure is closed, however, panel tamper has been
detected and cleared (Panel tamper memory).
Animated Solid Blinking
Call on Nexus
A telephone call is in progress via the Nexus com-
municator
Solid Solid
Sending SMS
An SMS text message is being sent through the
Nexus/G dialer
Solid Solid
LAN
A SIA-IP event report is being sent through the
LAN
Solid Solid
The LAN board cannot be found
Blinking Blinking
SIA-IP on Nexus
A SIA-IP event report is being sent through the
Nexus
Solid Solid
Thermostat:
Winter mode
The keypad thermostat option is enabled in Winter
mode (Heating).
Solid Solid
Thermostat:
Summer mode
The keypad thermostat option is enabled in Sum-
mer mode (Air-conditioning).
Solid Solid
Thermostat:
Heating/Air-condi-
tioning
Heating/Air-conditioning On.
Solid Solid
To Next Page
Loading...
