User’s manual
Keypads 41
To assign the shortcuts to the function keys, work through the following steps.
1. Use keys and to select the key you wish to associate with the shortcut then
press OK.
2. Press OK then, using keys and , select from the “Type” list the shortcut you
wish to associate with the function key.
3. Press OK to confirm and exit.
4. If the shortcut is associated with “Arm/Disarm” operations, the system will ask you to
select a scenario. If the associated shortcut is “Activate output” or “Deactiv. output”, the
system will ask you to select an output.
• ActivatableOutputs - this section allows the user to enable/disable the outputs the code
is allowed to control manually:
User
menu, Outputs ON/OFF
.
1. Use keys and to select the desired output.
2. Use keys and to enable/disable manual control of the output for the code
concerned.
3. Press OK to confirm and exit.
• Timers - this section allows you to assign a timer to the code. The code will be operative
only at the pre-set times.
• Type - this section allows you to assign a level (rank) in the system hierarchy to the
selected code.
• Enablements - this section allows you to enable/disable access to the various sections of
the user menu.
The programming steps are identical to those of “Outputs ON/OFF”.
6-6-14
Timer programming
This section allows the programming of all the timers the user has access to.
You can program two “ON” times and two “OFF” times for each day of the week.
A timer can be associated with:
•a Partition - if the timer is enabled and the partition is enabled for automatic-arming
operations (refer to paragraph 6-6 Operations from LCD keypads), the partition will arm
when the timer switches ON and disarm when the timer switches OFF.
•a Code - if the timer is enabled, the code will be authorized to operate on the system only
when the timer is active (ON).
•a Key - if the timer is enabled, the key will be authorized to operate on the system only
when the timer is active (ON).
If you wish to associate a timer with a partition or a code, you must access the respective
section in the user menu. The association of timers with keys must be done by the installer
during the programming phase.
Access the “Timers” section of the user menu by typing-in a valid code PIN.
1. Use keys and to select the Timer then press OK.
2. Using the same keys, select the day of the week.
3. Select an activation or a restoral of the timer.
4. Set the selected time (expressed in hours and minutes) by means of keys and
then, using keys and select the number.
5. Press OK to confirm and exit.
It is possible also to program timer activation only or timer reset only.
If you do not wish to program the timer activation or restoral setting, enter “--:--” in the field
you do not wish to program.
TIMER 001
Activation 1
Activation 2
Restoral 1
TIMER 001
Sunday
Monday
Tuesday
User Code
Nexus Nexus
Codes
Timers
Timers
TIMER 001
TIMER 002
TIMER 003
TIMER 001
--:--
To Next Page
Loading...
