User’s manual
Keypads 43
6-7-2
Alarm management
The typical operations the user must perform in the event of alarms and/or tamper conditions
are:
• Stop the ongoing alarms by deactivating the outputs related to the system alarm and
tamper events.
• Cancel the entire call queue and stop ongoing calls (if any).
• Delete the alarm and tamper memories.
To perform these operations, it is necessary to access the “Menu” section, enter the user code
and then access the “Actions” section.
This section contains a list of control panel commands which can be activated by means of the
ACTIVATE button.
6-7-3
Arming commands and scenarios
The Alien keypad allow users to activate the programmed scenarios and also set up the
arming mode of the partitions they control (have access to):
In the case of arming requests in conditions of reduced security (partitions not ready or faults
present) the keypad will show the list of causes of reduced security.
SCENARIOS
• Access “Scenarios” section This section provides a list of the scenarios which can be
activated by means of the ACTIVATE button.
Tapping the bottom bar on the home page will open (for 3 seconds) a window containing a list
of the active scenarios. If required by programming, the system may request entry of a valid
user code (“Show scenario with code”,paragraph 6-7-9 Keypad settings).
PARTITIONS
• Access the “Intrusion” section, type-in the user code and then access the “Partitions”
section.
This section displays the partitions separately. You can scroll and select a partition by means
of the right/left scroll buttons and then select the arming mode by means if up/down buttons.
- “D”, to disarm.
- “A”, to arm in Away mode (entire system armed)
- “S”, to arm in Stay mode (system partially armed).
- “I”, to arm in Instant mode (no delays)
- “N”, not to change the operating status.
To apply the selected arming mode , press the OK button.
6-7-4
Voice memo and intercom functions
When accessing voice functions via the Alien touch screen, first access the “Apps” section and
then the “Voice functions” section.
Following is a list of the sections relating to each function which can be activated by pressing
the respective ON button:
• Record message in the voice memo box
• Playback message in the voice memo box
• Delete message in the voice memo box
• Voice communication with another keypad.
The sections accessed through the touch screen reproduce the same voice functions as those
previously described for keypads with keys.
APPS
Accesses the applications of the Alien touch screen interface:
• “Photo frame” - application that starts a slideshow of the images contained in the
inserted SD-card (see paragraph 6-8 Photo frame).
• “Voice functions” accesses a section where it is possible to activate the control panel
voice board functions or the “Intercom” function. Refer to paragraph 6-7-4 Voice
memo and intercom functions.
• “Maps” - for access to the system by means of the graphic maps (refer to Chapter 10
, Graphic maps).
•“Alarm clock”,
• “Memo” - application for the programming and activation of audible signalling and
popups on the Alien keypad (refer to paragraph 6-9 Alarm clock and memo).
No code requested
CLIMATE
Accesses the thermostat functions section
Refer to paragraph 6-7-13 Thermostat.
No code requested
Table 6-19: Alien keypad menu
Icon/key Function Code required
To Next Page
Loading...
