User’s manual
How to use the PrimeLAN 59
9-3-4
Camera access
The web interface allows the user to view the image stream or video in real time and the
image recordings which precede and follow the occurrence of an event.
This is possible through the “Cameras” section, where the camera shots configured through
the appropriate programming of the PrimeLAN board can be viewed.
Two sections are available:
REAL-TIME
• “Real-time” - allows you to view the configured cameras and relative video recordings in
real-time.
Each camera has a box that shows:
•• information regarding the camera (description, make, time, date, etc.
•• snapshots taken in real-time
•• Snapshots button - allows you to view the recorded footage in snapshot sequence
•• Video button - allows you to view the recorded footage in video format
RECORDINGS
• “Records” - allows you to view recorded footage after the occurrence of an event.
Each box provides:
•• information regarding the event that triggered the video recording (description, time,
date)
•• first snapshot of the recorded sequence
•• View button - allows you to view the recorded camera footage in specific snapshot
sequence (the snapshots which immediately precede and follow the occurrence of the
event)
Depending on the type and make of camera, it may be possible to use the pan, tilt and zoom
(PTZ) commands for viewing or select one the preset for viewing or operating modes provided
by the camera.
9-3-5
Remote keypads
The “Keypads” section of the web interface of a Prime control panel provides access to the
replication of one of the keypads connected to the control panel.
This section allows you to use the replica keypad, with its keys, display and LEDs, to operate
on the system after access from remote locations.
Besides the keypad buttons (described in paragraph 6-2 Using the keys) there are also other
buttons:
• , to access the home page of the web interface
• , to open a window for the selection of the keypad to be replicated
To Next Page
Loading...
