58 How to use the PrimeLAN
Anti-intrusion control panels
• Events log- first access the “Intrusion” section then the “Events log”.
A window will appear which provides buttons to indicate the number of events to be
viewed, starting from the last.
Once accessed, this section provides a list of events with the respective details and the
relative PARTITIONS button which, if pressed, opens a window containing a list of the
partitions involved in the event.
• System info - accessing the “System” section provides the following sub-sections:
•• “Faults list” - this window showing a list of the faults present on the system.
•• “Voltage” - this window allows you to view the control panel power-supply voltage.
•• “GSM info” - this window allows you to view the parameters of the Nexus GSM
communicator.
Via Graphic
maps
The viewing of the Prime system status and the monitoring of its parts can be done through
the graphic maps function, accessible through an Alien keypad or web interface.
Refer to Chapter 10 , Graphic maps.
Table 9-4: Viewing via web
Section Icon Status
Partitions/Zones
Disarmed
Armed in Away mode
Armed in Stay mode
Armed in instant mode
Stand-by
Alarm
Tamper or fault
An alarm or tamper event in memory
Zones
Zone shorted
Zone active
Zone deactivated
Timer
Activated
Deactivated
Output status
Table 9-5: Activations via web
Section Button Function
Zones
ON
Enables zone
OFF
Disables zone
ON
Activates output
OFF
Deactivates output
bar
scroll bar for adjustments to the power/current
supplied to the high-power relay outputs and dim-
mer outputs
To Next Page
Loading...
