EasyManua.ls Logo

INIM SmartLight/S - Device Identifier; Warranty

INIM SmartLight/S
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 General information
Installation and programming manual
2.13 Device identifier
Figure 2 - Overview
Figure 3 - CE Approval
2.14 Warranty
INIM Electronics s.r.l. warrants the original purchaser that for a period of 24 months from the date of final
acceptance, the product shall be free of defects in materials and workmanship. The warranty applies only
to defects in parts and workmanship relating to normal use. It does not cover:
Improper use or negligence
Damage caused by fire, flood, wind or lightning
Vandalism
Fair wear and tear
INIM Electronics s.r.l. shall, at its option, repair or replace any defective products. Improper use, that is,
use for purposes other than those mentioned
in this manual
which is the cause of fault or damage to the
system, will void the warranty. For the full details and conditions regarding the warranty, refer to the
purchase order.
Approved / Aprobado
Alimentazione /
LBDTIN4ASLIGHTG
I
/G
02/2012
230V~ -15% + 10%
Power / Alimentacion
50/60 Hz
Consumo /
Consumption / Consumo
0.5 A
Classe
Approvato /
EN54-2, EN54-4
MADE IN ITALY
0051-CPD-0223
Isolamento /
Isolation / Aislamiento
0051
09
0051 - CPD - 0222
Control and signaling panel with integrated
power-source devices.
SmartLIGHT/S


Isolation: Class I
Available options:
- 7.8 Sounder circuits output
- 7.11 Delayed outputs
- 7.12 Alarm on two points activation
- 8.3 Fault from points signal
- 8.9 Monitored output for remote signalling
- 9.5 Points isolation
- 10.0 Test condition
Manufacturer: INIM Electronics s.r.l.
Address: via Fosso Antico, Centobuchi
63076, Monteprandone (AP), Italy
0051
09
0051 - CPD - 0223
Control and signaling panel with integrated
power-source devices.
SmartLIGHT/G


Isolation: Class I
Available options:
- 7.8 Sounder circuits output
- 7.11 Delayed outputs
- 7.12 Alarm on two points activation
- 8.3 Fault from points signal
- 8.9 Monitored output for remote signalling
- 9.5 Points isolation
- 10.0 Test condition
Manufacturer: INIM Electronics s.r.l.
Address: via Fosso Antico, Centobuchi
63076, Monteprandone (AP), Italy

Table of Contents

Related product manuals