14 Device management
Installation and programming manual
Chapter 3
Device management
3.1 Product handling and storage
This device is safely packed inside a cardboard box, however, care must be taken to avoid accidental
damage during handling. Cartons/boxes should be placed in such a way as to avoid knocks and falls, and
special care must be taken to protect the devices from extreme heat and/or cold.
3.2 Environmental conditions
Temperature limits:
-10° / +55°C for transport and storage
-5° / +40°C operating temperature
3.3 Unpacking the device
Take due care when unpacking the product, and dispose of all waste packaging in accordance with the local
method of disposal.
The cardboard box contains the SmartLoop control panel (cabinet in metal).
Note: The two lead batteries @ 12 V - 7 Ah are not included. Be sure you have the batteries on hand before
starting.
When you remove the four screws and metal-frontplate, you will find:
• The SmartLight motherboard mounted on a plastic support that bridges the two sides of the metal box.
• Power supply module located under the plastic support. The power supply module is connected to the
SmartLight motherboard.
• A plastic bag containing:
- Battery connection wires
- Resistors and EOL diodes for supervised circuits
- Key for access level 2
The following accessory items must be ordered separately (see Appendix D - Order Codes):
• [A] SmartLetLoose/ONE - extinguishant module
• [B] SmartLetUSee/LCD-Lite - repeater panel
• [C] ProbeTH - thermal probe battery-charge optimizer which operates in accordance with the battery
temperature.
• [D] SmartLevel - power-supply station
To Next Page
Loading...
