INIM SmartLight/S - Appendix B Argus Devices

64 Argus Devices
Installation and programming manual
Appendix B
Argus Devices
Note: The ARGUS devices accepted by this control panel do not have IMQ-SECURITY SYSTEMS certification;
refer to the instructions leaflet provided with each device.
All Argus Vega devices have built-in loop isolators. Therefore, isolators are not required. A short-circuit on
the loop will not provoke loss of any device.
Each detector is equipped with a 3-colour LED: green (periodic blinking) indicates the detector is working
properly (if enabled). Yellow indicates fault or open isolator status; red indicates alarm status (if enabled by
the operator).
Detectors are equipped with test LEDs: if you hold a magnet near the detector base (near to the two
notches) the detector should generate an alarm signal.
B.1 Devices
Model Name Description
V100 Analogue optical smoke detector Optical smoke detector
V200 Analogue multicriteria detector Optical smoke and heat detector
V350 Analogue heat detector
Heat detector (
a
)
VCP100 Intelligent resettable callpoint Resettable callpoint
VWCP100 Weatherproof intelligent resettable callpoint Resettable callpoint for outdoor installation
VMI100 Input module Module with 1 supervised input
VMMI100 Input minimodule Minimodule with 1 supervised input
VMDI100 DIN rail input module DIN rail module with 1 supervised input
VUMI100 Input micromodule Micromodule with 1 supervised input
VMC100 Output module Module with 1 supervised output
VMMC100 Output minimodule Minimodule with 1 supervised output
VMDC100 DIN rail output module DIN rail module with 1 supervised output
VUMC100 Output micromodule Micromodule with 1 supervised output
VMC120 Output module Form C Module with 1 voltage free relay (non-supervised)
VMMC120 Output minimodule Form C Minmodule with 1 voltage free relay (non-supervised)
VMDC120 DIN rail output module Form C DIN rail module with 1 voltage free relay (non-supervised)
VUMC140 Output micromodule Form C Micromodule with 1 voltage free relay (non-supervised)
VMIC100 Input/Output module Module with 1 supervised input + 1 supervised output
VMMIC100 Input/Output minimodule
Minimodule with 1 supervised input + 1 supervised output
VMDIC100 DIN rail input/output module DIN rail module with 1 supervised input + 1 supervised output
VMIC120 Input/Output module Form C Module with 1 supervised input + 1 non-supervised output (voltage
free contact)
VMMIC120 Input/Output minimodule Form C Minimodule with 1 supervised input + 1 non-supervised output
(voltage free contact)
VMDIC120 DIN rail input/output module Form C DIN rail module with 1 supervised input + 1 non-supervised output
(voltage free contact)