INIM SmartLight/S

To Next Page

To Previous Page

Installation and programming manual

Device management 15

Figure 4 - Accessory devices

Main Page

Default Chapter2
- Copyright2
- European Directive Compliance2
- Table of Contents3
- Application and Use5
Chapter 1 Overview5
- Other Parts of the System7
- In Order to Validate the IMQ-SECURITY SYSTEMS Certification, and in Compliance with EN54-2 Regulations8
- The Smartlight Fire Alarm Panel Models8
Chapter 2 General Information9
- Documentation Supplied9
- Firmware Information9
- Intellectual Property Rights9
- Manual Details9
- Operator Qualifications - Access Levels9
- Conventions10
- Disclaimer10
- Note to the Installer10
- Recommendations10
- Technical Support10
- Testing the System10
- Menu Paths11
- Device Identifier12
- Warranty12
- Safety Laws13
Chapter 3 Device Management14
- Environmental Conditions14
- Product Handling and Storage14
- Unpacking the Device14
Chapter 4 Technical Description16
- Internal Devices16
- PCB Current Draw17
- Technical Specifications17
Chapter 5 User Interface18
- Smartlight Panel Frontplate18
- Internal Leds22
- Repeater (Optional System Enhancement Panel)23
Chapter 6 Installation Instructions26
- Installing the Extinguishant Module (Accessory Item)26
- Wall Mounting26
- Connecting the Loop27
- Connecting the Dialer28
- Connecting the RS485 BUS29
- Connecting the Fault Signaling Outputs30
- Connecting the Alarm Signaling Output31
- Connecting the Extinguishant Module (Optional)32
- The AUX Output33
- Connecting the Batteries34
- Connecting the Mains34
- Thermal Probe35
Chapter 7 Powering up and Configuring the System37
- Testing Wiring Integrity37
- Connecting the RS232 PC Serial Link37
- Powering up the System38
Chapter 8 Programming from the Panel40
Chapter 9 Preparing the Programming Data41
- Setting Delays and Times41
- Other Options41
- Defining Zones42
- Setting Holidays42
- Setting the Timers42
Chapter 10 Configuring the Loop44
- Defining Loop Typology44
- Adding/Removing any Type of Device Manually44
- Configuring the Devices45
- Checking Enrolled/Addressed Devices45
Chapter 11 Programming Fire Detection Points46
Chapter 12 Programming the Extinguishant Module49
- Configuring the Extinguishant Module50
- Programming the Module50
- Programming Extinction Points51
Chapter 13 Configuring the Devices Connected to the RS485 BUS53
Chapter 14 Closing the Programming Session54
Chapter 15 Smartleague Software55
- Overview55
- The Solutions55
- Enable Programming Via PC55
Chapter 16 Maintenance56
- View Events56
- Day/Night Mode56
- Bypassing a Zone or Point57
- Bypass Dialer Output and Supervised Fault57
- Testing Points and Zones57
- Force the Leds and Point Outputs57
- Set the Date for the Next Maintenance Session58
- Loop Diagnostics58
Chapter 17 Diagnostics and Fault Solutions59
- Shorted I/O" Fault59
- Loop Fault59
- Testing the Loop59
- Repeater Faults60
- Battery Fault60
- Other Faults60
Appendix A Enea Series Devices61
Appendix B Argus Devices64
Appendix C Apollo Devices67
Appendix D Order Codes71

INIM SmartLight/S - Page 15

Table of Contents

Related product manuals