Installation and programming manual
Preparing the programming data 43
9.6.1 Parameters
Timer Timer number (maximum 8), preset.
Interval 1, Start/End Hour and minutes of the Start and End of the interval 1. If you do not wish to
specify an interval, leave “--”.
Interval 2, Start/End Hour and minutes of the Start and End of the interval 2. If you do not wish to
specify an interval, leave “--”. If both intervals are set as “--”, the timer will
operate on a 24 Hour basis.
day, month, year Operational date of the timer. To indicate any day, month or year, leave “--” (for
example, every 3rd of the: day=3, month = “--”, year = “--”). Day, month or
year should be “--”, if you wish to create the setting using the day of the week.
Sunday, etc. Day of the week for weekly arrangements. Valid only when the Day, month,
year are set as “--”. If you select Holiday the timer will operate on the
respective dates (refer to paragraph 9.5 - Setting holidays).
Force night Activation of the timer will switch the panel to Night mode. The panel cannot be
switched back to Day mode until the set timer interval expires. Once the set
timer interval expires, the panel can be switched back to day mode either by
another timer or manually from the panel (refer to paragraph 16.2 - Day/Night
Mode).
Set day Activation of the timer will switch the panel to Day mode. The panel can be
switched back to Night mode either by another timer or manually from the panel.
Set night Activation of the timer will switch the panel to Night mode. The panel can be
switched back to Day mode either by another timer or manually from the panel.
Zone Number of the zone to be bypassed/unbypassed.
Disable zone Activation of the timer will bypass the specified zone.
Enable zone Activation of the timer will unbypass the specified zone.
To Next Page
Loading...
