User’s Manual Innomar SES Parametric Sub-bottom Profilers 93
Innomar Technologie GmbH (2020-09) 93
This example would copy the valuus from a GGA string as shown above to SIS strings. Of course
NMEA settings should be used for GGA sentence.
6.3.5 Save and Reload SIS Settings
All settings made in the “Navigation Input” dialog can be saved into a *.nav file and reloaded. It
saves a lot of time if a survey takes place on the same ship with the same GNSS equipment once
more. Save the data of the SIS settings for example as NameOfShip.nav or NameOfGNSS.nav
6.3.6 Replace SIS Strings with Other Data
SIS strings defined in the “NAV Input” dialogue may be replaced with other values by some other
SESWIN features like
UTM conversion, see section 4.11.10 on page 60 and section 6.4 on page 94,
Position data offset correction, see section 0 on page 63,
Multi-purpose input (serial interface to obtain other sensor data), see section 0 on page
65.
If one of these features is used, take care not to overwrite any important SIS string!
To Next Page
Loading...