Inovance AC800 Series - Page 43

-43-
AC800 Series Intelligent Machine Controller Hardware User Guide 6 Operating Instructions
(2) Network port information
Network
port
screenprint
Function Network port information Physical address [Note] Remarks
LAN A
EtherNET
圳坒坕块圃A 坌坑坉坒
192.168.153.122
255.255.255.0
192.168.153.1
1. ADDEAF3C59FD
2. DDE529CBEE4C
3. FC F2CD77ACB2
4. E2368ADEC69F
Support factory
recovery, see
section 6.3.3.2 (5)
for details
LAN B
--
LAN C
EtherCAT
--
LAN D
[Note] The physical address of each network port can be viewed through "Network Port MAC".
(3) Expansion card
The equipment supports CAN expansion cards (option). After inserting the CAN card, you can check the
software version of the card through the following screen. If the information fails to show, reconnect the
card. If the problem remains, contact Inovance.
2 Settings
(1) Password
The Settings menu contains high permission level operations on the PLC. If you have not set a password
through the InoProShop tool (see xxxxxx for details) or you set the password to "0000" (regarded as no
password), you can use the Settings menu directly. If you have set a valid 4-digit password through the
InoProShop tool, you will be prompted to enter the password when entering the submenu of Settings.
圳坄坖坖坚坒坕均
0
圳坄坖坖坚坒坕均
* * * 8
Password page
■ After you enter the password page, the 󶍾rst digit of the password, which is 0, 󶍿ashes. Press the Up/
Down keys to cycle through digits from 0 to 9.
■ When you get the desired digit, press "Enter" to input the digit.
■ Every time one digit is input, the focus will move to the next input 󶍾eld. Enter the digits in sequence
to input the whole password.
■ You cannot backspace any input digit because no such function is provided. You have to press the
Back key to return to the previous menu, and then press the Enter key to re-enter the password page.
Entering the password
■ The digit that you are currently inputing will be displayed in plain text. After pressing Enter, the digits