Inovance IS 300 Series - Page 86

IS300 Series Servo Drive User Manual Appendix
- 85 -
Function
Code
Name Setting Range Min. Unit Default Property
F7-03
QUICK parameter
locking
0: Invalid
1: Valid
1 1 ☆
F7-04
LED displaying
running
parameters
0–65535 1 624 ☆
F7-05
LED displaying
stop parameters
1–65535 1 1139 ☆
F7-06
Load speed
display coefficient
0.0001–6.5000 0.0001 1.0000 ☆
F7-07
Heat sink
temperature 1
0.0℃–100℃ 1℃ - ●
F7-08
Heat sink
temperature 2
0.0℃–100℃ 1℃ - ●
F7-09
Accumulative
running time
0–65535 h 1 - ●
F7-10
Software version
No.1
- - - ●
F7-11
Software version
No.2
- - - ●
Group F8: Auxiliary Functions
F8-00
JOG running
frequency
0.00 Hz–max. frequency
0.01 Hz 2.00 Hz ☆
F8-01
JOG acceleration
time
0.0s–6500.0s 0.1s 20.0s ☆
F8-02
JOG deceleration
time
0.0s–6500.0s 0.1s 20.0s ☆
F8-03
Acceleration time 2
0.0s–6500.0s 0.1s 20.0s ☆
F8-04
Deceleration time 2
0.0s–6500.0s 0.1s 20.0s ☆
F8-05
Acceleration time 3
0.0s–6500.0s 0.1s 20.0s ☆
F8-06
Deceleration time 3
0.0s–6500.0s 0.1s 20.0s ☆
F8-07
Acceleration time 4
0.0s–6500.0s 0.1s 20.0s ☆
F8-08
Deceleration time 4
0.0s–6500.0s 0.1s 20.0s ☆
F8-09 Jump frequency 1 0.00 Hz–max. frequency 0.01 Hz 0.00 Hz ☆
F8-10 Jump frequency 2 0.00 Hz–max. frequency 0.01 Hz 0.00 Hz ☆
F8-11
Frequency jump
amplitude
0.00 Hz–max. frequency
0.01 Hz 0.00 Hz ☆
F8-12
FWD/REV dead-
zone time
0.0s–3000.0s 0.1s 0.0s ☆
F8-13 REV control
0: Enabled
1: Disabled
1 0 ☆