Mechanical Installation (T10 to T12 Models)
‑100‑
5.5.2 Installing the Cover
Remove the cover before wiring the main circuit and control circuit. After the wiring is
completed, install the cover back.
PPrroocceedduurree
1. Hold the cover with your hands, align its upper edge with the upper edge snap on
the chassis, and snap them together, with the snap‑fit joint in the position shown in
the following figure. Then align the six screw mounting holes in the cover with the
cover mounting holes in the chassis and press them tightly against each other.
2. Drive six fixing screws into the holes with a screwdriver to fasten the cover.
To Next Page
Loading...
