Installation Preparation
‑23‑
T13 models
"
Table 1–5 Tools for mechanical installation
"
on page 23
lists the tools for mechanical
installation.
Table 1–5 Tools for mechanical installation
Tool
Description
Wrench or socket wrench (18 mm)
Used to tighten or loosen screws.
Phillips and slotted (2.5–6 mm)
screwdrivers
Used to tighten or loosen screws.
Torque wrench (torque above 100 N•m) Used to tighten or loosen screws.
Electric drill with an appropriate drilling bit
Used to drill holes into the floor or steel
plates for fastening the cabinet.
Crowbar
Used to pry off the upper access cover or
cover to facilitate installation.
Crane
Used to lift the equipment.
Tape measure
Used to measure the installation
dimensions of the equipment.
Gloves
Used to prevent static electricity.
1.3.2 Wiring Tools
For wiring of main circuit terminals, consider the terminal dimensions and use
appropriate installation tools to secure the joints. For details about the required tools
for wiring of the main circuit terminals, see "
Table 1–6 Tools for wiring of main circuit
terminals
"
on page 23
.
Table 1–6 Tools for wiring of main circuit terminals
Model Recommended Fastener Tools
T1 to T2 M4 SEMS screw
Phillips screwdriver (#3)
T3 to T4 M5 SEMS screw
Phillips screwdriver (#3)
T5 to T6 M6 SEMS screw
Phillips screwdriver (#3)
T7
M8 nut, spring washer, and
flat washer
Socket wrench (13 mm)
T8 to T9
M12 nut, spring washer, and
flat washer
Socket wrench (19 mm) and
socket wrench extension bar
(150 mm)
T10 to T11
M12 bolt, spring washer, and
flat washer
Socket wrench (19 mm) and
socket wrench extension bar
(250 mm)
To Next Page
Loading...
