Installation Preparation
‑22‑
Tool
Description
Guide rails (optional)
When the AC drive is installed in a cabinet,
the guide rails are connected to the bottom
mounting bracket, allowing the AC drive to
be gently pushed into the cabinet along the
guide rails.
Screws
Used to fix the equipment onto the
mounting surface.
"
Table 1–3 Specifications and quantities of screws
"
on page 22
lists the specifications
and quantities of screws required for mechanical installation.
Table 1–3 Specifications and quantities of screws
Installation Method
Specification
Quantity
(Pieces)
Description
Backplate Mounting
Dependent on the
mounting hole
diameter (purchased
by the user).
4
Used to fix the equipment
onto the wall.
Through‑hole
mounting
Dependent on the
mounting hole
diameter (purchased
by the user).
4
Used to fix the AC drive onto
the backplate of the control
cabinet.
T10 to T12 models
"
Table 1–2 Tools for mechanical installation
"
on page 21
lists the tools for mechanical
installation.
"
Table 1–4 Specifications and quantities of screws
"
on page 22
lists the specifications
and quantities of screws required for mechanical installation.
Table 1–4 Specifications and quantities of screws
Installation Method
Specification
Quantity
(Pieces)
Description
Installation in a
cabinet
M5 self‑tapping
screw
6
Used to fix the bottom
mounting bracket to the
bottom of the cabinet.
M5 x 12 SEMS screw 8
Used to make the guide rail
assembly.
M6 nut 2
Used to connect the guide
rail assembly to the bottom
mounting bracket.
To Next Page
Loading...
