Inovance MD500-PLUS Series - Grounding Bracket of Cable Shield; Bottom Mounting Bracket

Installation Preparation
‑34‑
1.4.2 Grounding Bracket of Cable Shield
The grounding bracket of cable shield is optional and can be purchased separately as
required (applicable to T9 models and below).
1.4.3 Bottom Mounting Bracket
The bottom mounting bracket is standard for T10 to T12 models. When the AC drive is
installed in a cabinet, a bottom mounting bracket is required for fixing the AC drive to
the cabinet rack base. The dimensions of bottom mounting bracket depend on the
power rating, weight, and size of the AC drive, as shown in the following figures.
A 600 mm cabinet is delivered with the AC drive. If you need an 800 mm cabinet,
contact Inovance.
Figure 1‑20 Dimensions of bottom mounting bracket for T10 models (mm)