Installation Preparation
‑21‑
Figure 1‑10 Installation direction (T10 to T12 models)
1.3 Installation Tools
1.3.1 Tools for Mechanical Installation
T1 to T9 models
"
Table 1–2 Tools for mechanical installation
"
on page 21
lists the tools for mechanical
installation.
Table 1–2 Tools for mechanical installation
Tool
Description
Electric drill with an appropriate drilling bit
Used to drill mounting holes into the
mounting surface.
Wrench or socket wrench
Used to tighten or loosen screws.
Wrench sizes include 13 mm, 16 mm, and 18
mm.
Phillips and slotted (2.5–6 mm)
screwdrivers
Used to tighten or loosen screws.
Torque wrench Used to tighten or loosen screws.
Crowbar
Used to pry off the upper access cover or
cover to facilitate installation.
Crane
Used to lift the equipment.
Tape measure
Used to measure the installation
dimensions of the equipment.
Gloves
Used to prevent static electricity.
Bottom mounting bracket (standard)
When the AC drive is installed in a cabinet, a
bottom mounting bracket is used to fix it in
the cabinet.
To Next Page
Loading...
