Mechanical Installation (T1 to T9 Models)
‑77‑
The following figure shows an AC drive that is through‑hole mounted.
4.6 Removing and Installing the Cover
4.6.1 Removing the Cover
When wiring the control circuit, remove the cover before proceeding with any jumper
operation or connecting any PG card or extension card. When removing the cover,
hold the cover with your hands and carefully lift the lower part of the cover to prevent
the cover from falling off. Failure to comply may result in equipment damage or
human injury.
PPrreerreeqquuiissiitteess
Before removing the cover, ensure that the AC drive has been powered off for longer
than 10 minutes.
CCoonntteexxtt
The following figure shows the positions of the control board, jumper and extension
card with the cover removed.
To Next Page
Loading...
