Unpacking and Transportation
‑57‑
3.4 Unpacking
T1 to T12 models
The document suite and accessories are placed in different partitions in the crate.
Observe the following steps to unpack the AC drive:
1. Remove all ties and take off the cover.
2. Remove all filling materials.
3. Take out the AC drive.
4. Remove the plastic wrap around the AC drive by cutting.
5. Check that there is no damage.
6. Dispose of or recycle the packaging in accordance with local regulations.
T13 models
1. During unpacking, put the claw bar into the wooden crate case as short as possible
to prevent damaging the cabinet. Exercise caution to avoid injury by iron nails.
2. When removing the inner packing materials such as plastic film, use no sharp tools
to avoid scratching the cabinet.
3. Place a well‑packaged product in an open and flat workshop and use an iron claw
bar to pry off the wooden crate carefully. Then, remove the cover and the side and
end plates.
Figure 3‑12 Unpacking the AC drive
To Next Page
Loading...
