Mechanical Installation (T1 to T9 Models)
‑85‑
Figure 4‑12 Cable shield wiring
4.8 Installing the Conduit Box
CCoonntteexxtt
● Models requiring UL Type 1 enclosure have a conduit box.
● The conduit box is optional and can be purchased as needed (applicable to T6
models and below). For T5 to T6 models, follow the following steps to install a
conduit box.
PPrroocceedduurree
1. Lift the upper cover of the AC drive (as shown in Figure ①) to remove it, and then re‑
move the wire slot plate (as shown in Figure ②).
2. Remove the five M4 x 10 SEMS screws from the conduit box.
To Next Page
Loading...
