Mechanical Installation (T10 to T12 Models)
‑98‑
Figure 5‑11 Pushing the AC drive into the cabinet
6. Remove the auxiliary strap, and drive screws into the four mounting holes in the
back of the AC drive to fasten the AC drive to the fixing beam in the cabinet.
Figure 5‑12 Fastening the AC drive to the fixing beam
7. Verify that the AC drive is securely installed, and remove the guide rails.
8. Remove the air filter baffle from the top of the AC drive. The baffle is used to pre‑
vent foreign objects such as screws from falling into the air filter when the AC drive
is being installed in the cabinet.
To Next Page
Loading...
