Inovance MD580 Series - Guide Rails; UVW Output Side Copper Busbars

Option Selection
‑109‑
Note
● The bottom mounting brackets shown in the preceding figures are applicable to
PS standard cabinets, sized either 800 mm (W) x 600 mm (D) or 800 mm (W) x 800
mm (D). Dimensions in parentheses are applicable to PS standard cabinets sized
800 mm (W) x 800 mm (D).
● Bottom mounting brackets delivered with T10 to T12 models are only applicable
to PS standard cabinets sized 800 mm (W) x 600 mm (D). For PS standard cabinets
sized 800 mm (W) x 800 mm (D), contact Inovance.
4.2.2 Guide Rails
For details of the guide rails, see Operation Instructions for MD500‑AZJ‑A3T10 Guide
Rail
.
4.2.3 UVW Output Side Copper Busbars
All MD580 models excluding those with the base (‑L) are delivered with UVW output
side copper busbars. To install the UVW output copper busbars, follow the steps
below:
1. Step 1: Use a screwdriver or cutting pliers to remove the three knockouts.
2. Step 2: Use the four plastic snap‑fit joints in the packing box to fasten the insulating
paper to the chassis through the four holes on the paper.