Electrical Design
‑56‑
electromagnetic interference caused by rapid changes in the output voltage of the
AC drive.
4. Power cables
Use shielded cables, or shield all the cables from the cabinet module to the motor
by using conduits.
5. Control cables and power supply cables
If a control cable must run across a power supply cable, arrange them at an angle
close to 90°.
3.3 Main Circuit Wiring
3.3.1 Main Circuit Terminals
T1 to T9 models
Figure 3‑4 Layout of main circuit terminals of T1 to T4 models
Figure 3‑5 Layout of main circuit terminals of T5 to T8 models
To Next Page
Loading...
