‑12‑
Fundamental Safety Instructions
● When the fuse is blown or the circuit breaker or earth leakage current breaker (ELCB)
trips, wait for at least the time designated on the equipment warning label before
power‑on or further operations. Failure to comply may result in death, personal injuries
or equipment damage.
● When the equipment is faulty or damaged, the troubleshooting and repair work must be
performed by professionals that follow the repair instructions, with repair records kept
properly.
● Replace quick‑wear parts of the equipment according to the replacement instructions.
● Do not use damaged equipment. Failure to comply may result in death, personal
injuries, or severe equipment damage.
● After the equipment is replaced, check the wiring and set parameters again.
Disposal
● Dispose of retired equipment in accordance with local regulations and standards.
Failure to comply may result in property damage, personal injuries, or even death.
● Recycle retired equipment by observing industry waste disposal standards to avoid
environmental pollution.
Safety Labels
For safe equipment operation and maintenance, comply with the safety labels on the
equipment. Do not damage or remove the safety labels. See the following table for
descriptions of the safety labels.
Safety Label Description
● Read through the safety instructions before operating the equipment.
Failure to comply may result in death, personal injuries, or equipment
damage.
● Do not touch the terminals or remove the cover with power ON or
within 10 min after power‑off. Failure to comply will result in an
electric shock.
To Next Page
Loading...
