5G INDOOR ROUTER FG2000e USER GUIDE 28
Guest Network Tab
The Wi-Fi guest network allows you to segregate traffic to a separate network rather than share access
to your Wi-Fi primary network. Use settings on this tab to set up or change Wi-Fi guest network
information. Connected devices must use the Wi-Fi settings shown on this screen to connect to the
guest 5G Indoor Router Wi-Fi network.
NOTE: To turn the Wi-Fi guest network on, you must select at least one band for Guest Network under
Band Selection on the Wi-Fi Settings tab and then select Save Changes.
NOTE: When IP Passthrough is turned on, Wi-Fi networking capabilities are set through the connected
host routing system. Settings on this page are not available. Go to Advanced > LAN > IPPT to turn IP
Passthrough off.
Settings
Guest network name (SSID): Enter a guest network name (SSID) to set up or change the guest
network name. The name can be up to 32 characters long.
Security: Select an option for Wi-Fi security:
• WPA3/WPA2 Transition (default) is the most secure method of Wi-Fi Protected Access and
should be used if possible for WPA2 and WPA3 compliant devices.
• WPA/WPA2 Mixed Mode can be used if some of your older devices do not support WPA2.
To Next Page
Loading...
