Inseego Wavemaker PRO FG2000e

To Next Page

To Previous Page

5G INDOOR ROUTER FG2000e USER GUIDE 57

Primary IPv4

IP address: The IP address for your 5G Indoor Router, as seen from the primary local network.

Normally, you can use the default value.

Netmask: The mask network setting for the FG2000e. The default value 255.255.255.0 is standard for

small (class "C") networks. If you change the LAN IP Address, make sure to use the correct netmask for

the IP address range of the LAN IP address.

MAC address: (read-only) The Media Access Controller (MAC) Address for the primary Wi-Fi interface

on your 5G Indoor Router. The MAC address is a unique network identifier assigned when a network

device is manufactured.

Turn on DHCP server: This checkbox turns the DHCP Server feature on or off. This should be left

checked. The DHCP server allocates an IP address to each connected device. NOTE: If the DHCP Server

is turned off, each connected device must be assigned a fixed IP address.

Start DHCP address range at: The start of the IP address range used by the DHCP server. If the IP is

set on the client device, use an IP address outside of this DHCP range; if the IP address is set using an IP

reservation, it will usually be inside this range. NOTE: Only expert users should change this setting.

End DHCP address range at: The end of the IP address range used by the DHCP server. If the IP is set

on the client device, use an IP address outside of this DHCP range; if the IP address is set using an IP

reservation, it will usually be inside this range. NOTE: Only expert users should change this setting.

DHCP lease time: The number of minutes in which connected devices must renew the IP address

assigned to them by the DHCP server. Normally, this can be left at the default value, but if you have

special requirements, you can change this value.

Guest IPv4

IP address: The IP address for your 5G Indoor Router, as seen from the guest network. Normally, you

can use the default value.