INSTEON Hub: Developer’s Guide
Page 31 © 2013 INSTEON
ALL-Link Cleanup Failure Report
ALL-Link Cleanup Failure Report (0x56)
What it does
Reports that an ALL-Link Group member did not acknowledge an ALL-Link Cleanup Command.
When you’ll get this An ALL-Link Group member that you are trying to control did not acknowledge the ALL-Link Cleanup
Command sent by the IM.
What you’ll get
7 bytes.
LED indication
None.
Related Commands
IM 0x58 ALL-Link Cleanup Status Report
32
Message Sent from IM to Host
Byte Value Meaning
1 0x02 Start of IM Command
2
0x56
IM Command Number
3 0x01
Indicates that this ALL-Link Group member did not acknowledge an ALL-Link Cleanup
Command.
Indicates the ALL-Link Group Number that was sent in the ALL-Link Cleanup
Command.
5 <ID high byte> The high byte of the INSTEON ID of the device that did not respond.
6 <ID middle byte> The middle byte of the INSTEON ID of the device that did not respond.
7 <ID low byte> The low byte of the INSTEON ID of the device that did not respond.
Notes
The IM automatically sends ALL-Link Cleanup messages to each member of an ALL-Link Group
following an ALL-Link Broadcast message. If the IM detects other INSTEON traffic during this process,
it will abort the ALL-Link Cleanup sequence. If the Cleanup sequence is aborted, you will not receive
this message nor will you receive a Cleanup acknowldgement message for any subsequent devices in
the ALL-Link Group. The Cleanup sequence proceeds in the order in which the devices in the ALL-
Link Group were added to the ALL-Link Database.
For each ALL-Link Cleanup message the IM sends, you will either receive an INSTEON Standard
Message Received
22
when the Responder sends you an ACK, or you will receive this message.
However, it can take awhile before you receive this message. Worst case, if the IM has to wait for a
clear line and then retries the Cleanup message for the maximum of five times, the wait will be 2.150
seconds after sending the ALL-Link Broadcast message, or 1.550 seconds after receiving the first
Cleanup acknowledgement or this message. If the Cleanup sequence was aborted due to other
INSTEON traffic, you will not get this message even then. However, you will receive ALL-Link Cleanup
Status Report
32
with a Status Byte of 0x15 (NAK) indicating that the Cleanup sequence was aborted.
It is possible that this ALL-Link Group member did in fact properly receive the ALL-Link Broadcast
message that preceded the ALL-Link Cleanup message.
To Next Page
Loading...
