101
Advanced Setup—Continued
Component Video Input
See “Component Video Input Setup” on page 52.
Digital Audio Input
See “Digital Audio Input Setup” on page 53.
Analog Audio Input
Multich See “Analog Audio Input Setup” on page 54.
Subwoofer Input Sensitivity
0 dB (default), 5 dB, 10 dB, 15 dB
Some DVD players output the LFE channel from their analog subwoofer output at 15 dB higher than normal.
With this setting, you can change the AV receiver’s subwoofer sensitivity to match your DVD player. Note that
this setting only affects signals connected to the AV receiver’s MULTI CH: SUBWOOFER jack.
If you find that your subwoofer is too loud, try the 10 dB or 15 dB setting.
Gamma Curve
The color range and the brightness characteristic of a reproduced image depend on the TV or projector. With this
setting, you can adjust the balance of the color signals (R, G, and B).
To view the TV picture while setting, press the [Enter] button. To return to the default, press the [CLR] button. The
“Gamma Curve” setting is set respectively of HDMI main, HDMI sub, and analog.
R Gamma 0 to R Gamma 9
G Gamma 0 to G Gamma 9
B Gamma 0 to B Gamma 9
The following graph shows the default settings.
24
32
48
64
80
96
128
160
192
224
Output
Input
Gamma0
Gamma7
Gamma9
Gamma8
Gamma6
Gamma5
Gamma4
Gamma3
Gamma2
Gamma1
To Next Page
Loading...
Need help?
General
