54
First Time Setup—Continued
If you connect a component to the AV receiver’s analog
multichannel input, you must assign that input to an
input selector. For example, if you connect your DVD/
BD player to the MULTI CH input, you must assign it to
the DVD/BD input selector.
Notes:
• To listen to the component connected to the
multichannel input, press the [Audio] button and
select the “Audio selector” (see page 125).
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
To use bi-amping, bridging or passive subwoofer, you
must change the “Speakers Type(Front)” setting. For
hookup information, see pages 21 to 23.
Notes:
• When bridging is used, the AV receiver is able to drive
up to 7.2 speakers in the main room.
• When bi-amping is used, the AV receiver is able to
drive up to 7.2 speakers in the main room.
• Before you change these settings, turn down the
volume.
Analog Audio Input Setup
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select “1. Input/Output
Assign”, and then press [Enter].
The “Input/Output Assign” menu
appears.
3
Use the Up and Down [q]/[w] but-
tons to select “5. Analog Audio
Input”, and then press [Enter].
The “Analog Audio Input” menu
appears.
4
Use the Left and Right [e]/[r]
buttons to select an input selec-
tor.
You can assign the multichannel input
to the following input selectors:
“DVD/BD”, “VCR/DVR”, “CBL/
SAT”, “Game”, “AUX1”, “AUX2”,
“TV/Tape”, “CD”, or “Phono”. If you
don’t want to assign the multichannel
input, set to “- - - - -”.
1. Input/Output Assign
1. Monitor Out
2. HDMI Input
3. Component Video Input
4. Digital Audio Input
5. Analog Audio Input
6. Gamma Curve
Multich
Subwoofer Input Sensitivity
- - - - -
0dB
1–5. Analog Audio Input
5
Press the [Setup] button.
The setup menu closes.
Speaker Settings
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
If you change these settings, you must run
Audyssey MultEQ
®
XT Room Correction and
Speaker Setup again (see page 58).
To Next Page
Loading...
Need help?
General
