121
Advanced Setup—Continued
Network
See “Network Settings” on page 132.
Firmware Update
Notes:
• Perform the firmware update only when an announcement is posted on the Integra Web site.
• It takes about 60 minutes to complete the firmware update.
• (DTR-80.1) When updating a firmware from a USB mass storage device, the AV receiver searches the device which
is connected earlier during power on. If two devices have been connected at the time of power on, the AV receiver
will search the device on the front panel.
Version
The current version of the firmware is displayed. The version is made up of the versions of the AV receiver and
Onkyo dock (if connected).
Receiver via NET: You can update the firmware via Internet. Check the network connection
before update.
via USB: You can update the firmware from a USB mass storage device.
You can update the AV receiver’s firmware. Do not shutdown the power of the AV receiver while update.
Universal Port via NET: You can update the firmware via Internet. Check the network connection
before update.
via USB: You can update the firmware from a USB mass storage device.
You can update the Onkyo dock’s firmware. Do not shutdown the power of the AV receiver while update.
Note:
This update shall not be performed when no dock is connected to UNIVERSAL PORT jack.
To Next Page
Loading...
Need help?
General
