144
Multi Zone—Continued
Notes:
• Only analog input sources are output by the ZONE 2/
3 PRE OUT and ZONE 2/3/4 L/R speaker terminals.
Digital input sources are not output. If no sound is
heard when an input source is selected, check if it’s
connected to an analog input.
• You cannot select different AM or FM radio stations
for your main room and Zone 2/3/4. The same AM/
FM radio station will be heard in each room. For
example, if you have an FM station for the main room,
that station will also be used in Zone 2.
• When you connect Zone 2 speakers directly to the AV
receiver, listening modes that require front high or
front wide speakers such as Dolby Pro Logic IIz
Height or Audyssey Dynamic Surround Expansion™
are unavailable.
• When you connect Zone 3 speakers directly to the AV
receiver, listening modes that require surround back
speakers such as Dolby EX, DTS-ES or THX Ultra2
Cinema are unavailable.
• When you connect Zone 4 speakers directly to the AV
receiver, listening modes that require surround speak-
ers are unavailable.
• When the input selector of Zone 2/3/4 is selected,
power consumption on standby mode slightly
increases.
• While Zone 2/3/4 is on, u functions will not work.
Adjusting the Volume for Zones
Muting Zones
Adjusting the Tone and Balance of Zone 2/3
Notes:
• Zones can also be unmuted by adjusting the volume.
• The volume, tone and balance functions cannot be set
when the “Zone2 Out” or “Zone3 Out” setting is set to
“Fixed” (page 142) and “Powered Zone2” or “Pow-
ered Zone3” setting is set to “Not Act” (page 141).
• Even if you repeatedly press the remote controller’s
[Zone] button to select zones, the last zone selection
will be retained once you have switched to other com-
ponents by pressing other Remote Mode buttons after
pressing the [Zone] button.
Remote
controller
On the remote controller, press
the [Zone] button repeatedly, and
then use the VOL [q]/[w] button.
AV receiver
On the AV receiver, press the
[Zone 2], [Zone 3] or [Zone 4]
button, and then press the Zone
Level Down and Up [w]/[q]
buttons.
Remote
controller
On the remote controller, press
the [Zone] button repeatedly, and
then press the [Muting] button.
To unmute a zone, on the remote
controller, press the [Zone]
button, and then press the
[Muting] button again.
1
AV receiver
On the AV receiver, press the
[Zone 2] or [Zone 3] button.
2
Press the AV receiver’s [Tone]
button repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use the Down and Up [–]/[+]
buttons to adjust the bass, treble
or balance.
• You can boost or cut the bass or tre-
ble from –10 dB to +10 dB in 2 dB
steps.
• You can adjust the balance from 0 in
the center to +10 dB to the right or
+10 dB to the left in 2 dB steps.
To Next Page
Loading...
Need help?
General
