2
C H A P T E R 1 Intel Express 510T Switch
2
Introduction to the product
Purpose of the switch The Intel Express 510T Switch uses your existing network cables to
integrate switching technology into your computer network.
Each device in a workgroup or a network segment can communicate
at a full wire-speed of 10Mbps or 100Mbps to provide:
• High-speed connectivity
• Simultaneous two-way communication between connected
devices
• Increased network throughput and performance
• Increased server availability
Physical features This switch offers the following features:
• Plug-and-play—no need to configure the module to use the basic
operations
• 24 x 10/100Mbps connections
• Two option slots for modules
• Front panel LEDs that show switch, port and traffic status
• Automatic detection of 110V and 240V power supplies
Hardware features The switch offers the following features:
• Each port can operate in one of three switching modes: cut-
through, fragment-free or store-and-forward
• Each port supports half- and full-duplex operation
• Simultaneous full wire-speed switching on all ports
• RMON support for Statistics, History, Alarm and Events
• Spanning tree support on all ports
• Flow control
• Permanent MAC address entries
500.book Page 2 Thursday, September 2, 1999 1:30 PM
To Next Page
