Intel NUC5i5MYBE User Manual

Intel NUC Board NUC5i5MYBE Technical Product Specification
38
1.12.1.1 System States and Power States
Under ACPI, the operating system directs all system and device power state transitions. The
operating system puts devices in and out of low-power states based on user preferences and
knowledge of how devices are being used by applications. Devices that are not being used can be
turned off. The operating system uses information from applications and user settings to put the
system as a whole into a low-power state.
Table 14 lists the power states supported by the board along with the associated system power
targets. See the ACPI specification for a complete description of the various system and power
states.
Table 14. Power States and Targeted System Power
Global States Sleeping States
Processor
States Device States
Targeted System
Power
(Note 1)
G0 – working
state
S0 – working C0 – working D0 – working state. Full power > 30 W
G1 – sleeping
state
S3 – Suspend to RAM.
Context saved to
RAM.
No power
D3 – no power
except for wake-up
logic.
Power < 5 W
(Note 2)
G1 – sleeping
state
S4 – Suspend to disk.
Context saved to disk.
No power
D3 – no power
except for wake-up
logic.
Power < 5 W
(Note 2)
G2/S5
S5 – Soft off. Context
not saved. Cold boot
is required.
No power
D3 – no power
except for wake-up
logic.
Power < 5 W
(Note 2)
G3 – mechanical
off
AC power is
disconnected
from the
computer.
No power to the
system.
No power D3 – no power for
wake-up logic,
except when
provided by battery
or external source.
No power to the system.
Service can be performed
safely.
Notes:
1. Total system power is dependent on the system configuration, including add-in boards and peripherals powered by
the system chassis’ power supply.
2. Dependent on the standby power consumption of wake-up devices used in the system.

Intel NUC5i5MYBE Specifications

General

Brand	Intel
Model	NUC5i5MYBE
Category	Motherboard
Language	English