On-board Connector/Header Overview Intel® Server Board S2400SC TPS
Intel order number G36516-002 Revision 2.0
Four 6-pin fan headers are designated as hot-swap system fans:
o Hot-swap system fan 1 (J2J5)
o Hot-swap system fan 2 (J2J6)
o Hot-swap system fan 3 (J2J7)
o Hot-swap system fan 4 (J2J8)
o Hot-swap system fan 5 (J3J2)
o Hot-swap system fan 6 (J3J3)
One 4-pin fan header is designated as a rear system fan:
o System fan 7 (J9A1)
Table 43. SSI 4-pin Fan Header Pin-out (J5J1, J7A1, J9A1)
Ground is the power supply ground
FAN_TACH signal is connected to the BMC to monitor the fan speed
FAN_PWM signal to control fan speed
Table 44. SSI 6-pin Fan Header Pin-out (J2J5, J2J6, J2J7, J2J8, J3J2 and J3J3)
Ground is the power supply ground
FAN_TACH signal is connected to the BMC to monitor the fan speed
FAN_PWM signal to control fan speed
Indicates the fan is present
Note: Intel
®
Corporation server boards support peripheral components and can contain a
number of high-density VLSI and power delivery components that need adequate airflow to
cool. Intel’s own chassis are designed and tested to meet the intended thermal requirements of
these components when the fully integrated system is used together. It is the responsibility of
the system integrator that chooses not to use Intel
®
developed server building blocks to consult
vendor datasheets and operating parameters to determine the amount of airflow required for
their specific application and environmental conditions. Intel Corporation cannot be held
responsible if components fail or the server board does not operate correctly when used outside
any of its published operating or non-operating limits.
To Next Page
Loading...
