Intel® Server Board S2400SC TPS Appendix D: POST Code Errors
Revision 2.0 Intel order number G36516-002
Table 54. POST Error Codes and Messages
System RTC date/time not set
PCI component encountered a PERR error
PCI out of resources error
Processor core/thread count mismatch detected
Processor cache size mismatch detected
Processor family mismatch detected
Processor Intel(R) QPI link frequencies unable to synchronize
Processor model mismatch detected
Processor frequencies unable to synchronize
BIOS Settings reset to default settings
Passwords cleared by jumper
Password clear jumper is Set
Processor 01 unable to apply microcode update
Processor 02 unable to apply microcode update
Processor 03 unable to apply microcode update
Processor 04 unable to apply microcode update
Processor 01 failed Self Test (BIST)
Processor 02 failed Self Test (BIST)
Processor 03 failed Self Test (BIST)
Processor 04 failed Self Test (BIST)
Processor 01 microcode update not found
Processor 02 microcode update not found
Processor 03 microcode update not found
Processor 04 microcode update not found
Watchdog timer failed on last boot
OS boot watchdog timer failure
Baseboard management controller failed self-test
Hot Swap Controller failure
Management Engine (ME) failed Self Test
Management Engine (ME) Failed to respond.
Baseboard management controller failed to respond
Baseboard management controller in update mode
Memory component could not be configured in the selected RAS mode
DIMM_A1 failed test/initialization
DIMM_A2 failed test/initialization
DIMM_A3 failed test/initialization
DIMM_B1 failed test/initialization
DIMM_B2 failed test/initialization
DIMM_B3 failed test/initialization
DIMM_C1 failed test/initialization
DIMM_C2 failed test/initialization
DIMM_C3 failed test/initialization
DIMM_D1 failed test/initialization
DIMM_D2 failed test/initialization
DIMM_D3 failed test/initialization
DIMM_E1 failed test/initialization
To Next Page
Loading...
Need help?
General
