Intel S2400SC - Integrated BMC Hardware: Emulex* Pilot III; Emulex* Pilot III Baseboard Management Controller Functionality

Intel® Server Board S2400SC TPS Platform Management Functional Overview
Revision 2.0 Intel order number G36516-002 59
Feature
Basic
Advanced
Acoustic Management
X
X
Diagnostic Beep Code Support
X
X
Power State Retention
X
X
ARP/DHCP Support
X
X
PECI Thermal Management Support
X
X
E-mail Alerting
X
X
Embedded Web Server
X
X
SSH Support
X
X
Integrated KVM
X
Integrated Remote Media Redirection
X
Lightweight Directory Access Protocol (LDAP)
X
X
Intel
®
Intelligent Power Node Manager Support
X
X
SMASH CLP
X
X
6.3
Integrated BMC Hardware: Emulex* Pilot III
6.3.1
Emulex* Pilot III Baseboard Management Controller Functionality
The Integrated BMC is provided by an embedded ARM9 controller and associated peripheral
functionality that is required for IPMI-based server management. Firmware usage of these
hardware features is platform dependent.
The following is a summary of the Integrated BMC management hardware features that
comprise the BMC:
 400MHz 32-bit ARM9 processor with memory management unit (MMU)
 Two independent10/100/1000 Ethernet Controllers with Reduced Media Independent
Interface (RMII)/ Reduced Gigabit Media Independent Interface (RGMII) support
 DDR2/3 16-bit interface with up to 800 MHz operation
 16 10-bit ADCs
 Sixteen fan tachometers
 Eight Pulse Width Modulators (PWM)
 Chassis intrusion logic
 JTAG Master
 Eight I
2
C interfaces with master-slave and SMBus* timeout support. All interfaces are
SMBus* 2.0 compliant.
 Parallel general-purpose I/O Ports (16 direct, 32 shared)
 Serial general-purpose I/O Ports (80 in and 80 out)
 Three UARTs
 Platform Environmental Control Interface (PECI)
 Six general-purpose timers
 Interrupt controller
 Multiple Serial Peripheral Interface (SPI) flash interfaces
 NAND/Memory interface
 Sixteen mailbox registers for communication between the BMC and host
 LPC ROM interface
 BMC watchdog timer capability
 SD/MMC card controller with DMA support
 LED support with programmable blink rate controls on GPIOs