Intel S2400SC - Baseboard Management Controller

Functional Architecture Intel® Server Board S2400SC TPS
44 Intel order number G36516-002 Revision 2.0
 In the dual mode (on-board video = enabled, dual monitor video = enabled), the on-
board video controller is enabled and is the primary video device. The add-in video card
is allocated resources and is considered the secondary video device. The BIOS Setup
utility provides options to configure the feature as follows:
Table 10. Video mode
On-board Video Enabled
Disabled
Dual Monitor Video Enabled
Disabled
Shaded if on-board video is set to "Disabled"
3.4.3
Baseboard Management Controller
The server board utilizes the following features of the embedded baseboard management
controller.
 IPMI 2.0 Compliant
 400MHz 32-bit ARM9 processor with memory management unit (MMU)
 Two independent10/100/1000 Ethernet Controllers with RMII/RGMII support
 DDR2/3 16-bit interface with up to 800 MHz operation
 12 10-bit ADCs
 Fourteen fan tachometers
 Eight Pulse Width Modulators (PWM)
 Chassis intrusion logic
 JTAG Master
 Eight I2C interfaces with master-slave and SMBus* timeout support. All interfaces are
SMBus* 2.0 compliant.
 Parallel general-purpose I/O Ports (16 direct, 32 shared)
 Serial general-purpose I/O Ports (80 in and 80 out)
 Three UARTs
 Platform Environmental Control Interface (PECI)
 Six general-purpose timers
 Interrupt controller
 Multiple SPI flash interfaces
 NAND/Memory interface
 Sixteen mailbox registers for communication between the BMC and host
 LPC ROM interface
 BMC watchdog timer capability
 SD/MMC card controller with DMA support
 LED support with programmable blink rate controls on GPIOs
 Port 80h snooping capability
 Secondary Service Processor (SSP), which provides the HW capability of offloading time
critical processing tasks from the main ARM core.