Intel S2400SC - Availability; Network Port Usage

Intel® Server Board S2400SC TPS Advanced Management Feature Support (RMM4)
Revision 2.0 Intel order number G36516-002 87
 The mounted device is visible to (and useable by) managed system’s OS and BIOS in both
pre-boot and post-boot states.
 The mounted device shows up in the BIOS boot order and it is possible to change the
BIOS boot order to boot from this remote device.
 It is possible to install an operating system on a bare metal server (no OS present) using
the remotely mounted device. This may also require the use of KVM-r to configure the OS
during install.
USB storage devices will appear as floppy disks over media redirection. This allows for the
installation of device drivers during OS installation.
If either a virtual IDE or virtual floppy device is remotely attached during system boot, both the
virtual IDE and virtual floppy are presented as bootable devices. It is not possible to present
only a single-mounted device type to the system BIOS.
7.2.1
Availability
The default inactivity timeout is 30 minutes and is not user-configurable. Media redirection
sessions persist across system reset but not across an AC power loss or BMC reset.
7.2.2
Network Port Usage
The KVM and media redirection features use the following ports:
 5120 – CD Redirection
 5123 – FD Redirection
 5124 – CD Redirection (Secure)
 5127 – FD Redirection (Secure)
 7578 – Video Redirection
 7582 – Video Redirection (Secure)