Intel® Server Board S2400SC TPS Platform Management Functional Overview
Revision 2.0 Intel order number G36516-002 69
The BMC IPMB slave address is 20h.
The BMC both sends and receives IPMB messages over the IPMB interface. Non-IPMB
messages received by means of the IPMB interface are discarded.
Messages sent by the BMC can either be originated by the BMC, such as initialization agent
operation, or by another source. One example is KCS-IPMB bridging.
The BMC implements both the IPMI 1.5 and IPMI 2.0 messaging models. These provide out-of-
band local area network (LAN) communication between the BMC and the network.
See the Intelligent Platform Management Interface Specification Second Generation v2.0 for
details about the IPMI-over-LAN protocol.
Run-time determination of LAN channel capabilities can be determined by both standard IPMI
defined mechanisms.
6.12.3.1 RMCP/ASF Messaging
The BMC supports RMCP ping discovery in which the BMC responds with a pong message to
an RMCP/ASF ping request. This is implemented per the Intelligent Platform Management
Interface Specification Second Generation v2.0.
6.12.3.2 BMC LAN Channels
The BMC supports three RMII/RGMII ports that can be used for communicating with Ethernet
devices. Two ports are used for communication with the on-board NICs and one is used for
communication with an Ethernet PHY located on an optional RMM4 add-in module.
6.12.3.2.1 Baseboard NICs
The on-board Ethernet controller provides support for a Network Controller Sideband Interface
(NC-SI) manageability interface. This provides a sideband high-speed connection for
manageability traffic to the BMC while still allowing for a simultaneous host access to the OS if
desired.
The NC-SI is a DMTF industry standard protocol for the side band management LAN interface.
This protocol provides a fast multi-drop interface for management traffic.
The baseboard NIC(s) are connected to a single BMC RMII/RGMII port that is configured for
RMII operation. The NC-SI protocol is used for this connection and provides a 100 Mb/s full-
duplex multi-drop interface which allows multiple NICs to be connected to the BMC. The
physical layer is based upon RMII, however RMII is a point-to-point bus whereas NC-SI allows 1
master and up to 4 slaves. The logical layer (configuration commands) is incompatible with
RMII.
The server board will provide support for a dedicated management channel that can be
configured to be hidden from the host and only used by the BMC. This mode of operation is
configured through a BIOS setup option.
To Next Page
Loading...
Need help?
General
