Rotary Chair Instruction for Use - English
Date: 2011-09-27 Page 19
3. If you have selected to move the chair to zero position before start of the test, the chair will
automatically move to zero.
4. Once the chair is ready the above dialog will close and test will begin.
5. Once the selected direction has been completed the test will automatically stop again. If the
per-rotary segment in the opposite direction has not yet been completed the software will
automatically start the per-rotary segment in the opposite direction immediately following the
defined stop time for the post-rotary segment.
6. If you have selected to move the chair to zero position after testing is complete, the chair will
now move to zero position.
To Next Page
Loading...
