CS3000, Users
Rev A, January, 2011
Page 10 of 35
1. Press the mode button to access the Mode menu. The display will show “Print".
This will allow the user to activate the print function by selecting “yes” or bypass
printing by selecting “no”. Press either the zero button or the lb/kg button to
toggle the display. When the desired setting is displayed press the mode button
to continue through the mode menu.
2. The display will show “b.LitE”. Press the Mode button. The flashing display
shows the current setting. Press either the zero button or the lb/kg button to
toggle through Auto, on, and off. With ‘Auto’ selected (default), the backlight will
automatically light up when low level light conditions are detected. When the
desired setting is displayed press the mode button to continue through the mode
menu.
3. The display will show “SEtP1”. Press the Mode button. The display shows the
current setting. When the weight displayed is equal to or greater than the set
point, the corresponding icon is displayed on the LCD. During normal weighing
mode, the S1 icon on the display will light when the weight is greater than or
equal to set point 1. The flashing digit may be incremented by pressing the
Lb/Kg button or decremented by pressing the ZERO button. To move one digit to
the left, press the TARE button. When the display shows the desired number,
press the mode button to continue through the mode menu.
4. The display will show “SEtP2”. Press the Mode button. The display shows the
current setting. During normal weighing mode, the S2 icon on the display will
light when the weight is greater than or equal to set point 2. The flashing digit
may be incremented by pressing the Lb/Kg button or decremented by pressing
the ZERO button. To move one digit to the left, press the TARE button. When
the display shows the desired number, press the mode button to continue
through the mode menu.
5. The display will show “vEr”. Press the Mode button and the display will show the
current version of firmware loaded in the scale. (view only function) Press the
Mode button.
6. The display will show “A. rt”. Press the Mode button. The display shows the
current setting. This number is how many readings will be averaged together
before the reading is sent to the display. Higher values will result in a more
stable reading, but will take longer to settle to the final value. Note that the scale
updates at 4Hz, so an Average Rate of ‘8’ equates to 2 seconds of averaging.
Enter a ‘1’ to effectively disable averaging. The flashing digit may be
incremented by pressing the Lb/Kg button or decremented by pressing the ZERO
button. To move one digit to the left, press the TARE button. When the display
shows the desired number, press the mode button to continue through the mode
menu.
7. The display will show “A.tHrS”. Press the Mode button. The display shows the
current Average Threshold setting. This setting enables dynamic averaging,
To Next Page
Loading...
